RHUB TM-510 Specifiche Scaricare il pdf (Pagina 200)

TM 9-2350-311-34-1

7-12 POWER LEAD WIRING HARNESS (M109A2) — CONTINUED

a. Removal

— Continued

7 Disconnect connector (1) at driver’s compartment bulkhead.

8 Remove two plastic straps (26), four screws (27), and four washers (28) to release wiring harness.

9 Remove 11 plastic straps (29), 11 screws (30), and 11 washers (31).

b. Disassembly

Disassemble wiring harness leads (TM 9-2350-311-20-1).

c. Assembly

Assemble wiring harness leads (TM 9-2350-31 1-20-1).

d. Installation

1 Install 11 plastic straps (29), 11 washers (31), and 11 screws (30).

2 Install two plastic straps (26), four washers (28), and four screws (27) to secure wiring harness.

3 Connect connector (1) at driver’s compartment bulkhead.

4 Connect slave start receptacle (19) to mounting plate (23) with four new Iockwashers (25) and four screws

(24).

NOTE

Wiring harness maybe removed from hull with slave start receptacle attached or

leads can be pulled out of receptacle with sockets as required. If wiring harness

removed is without receptacle, skip steps 5 and 6.

5 Install receptacle (19) as follows:

(a) Push receptacle (19) with mounting plate (23) from driver's compartment into battery compartment.

(b) Install new gasket (22), four new Iockwashers (21), and four screws (20) to battery compartment bulkhead.

7-64

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 352 353

Nessun commento

RHUB TM-510 Specifiche Pagina 200